Have fun with this one!
A few materials you are going to need are: two-liter plastic soda bottle or water bottle, a trash can, water, scissors and a bowl head froma metal pipe.
Using scissors, cut off the bottom of the bottle.
Poke a hole in the lid or cap so that the bowl head can be screwed in. Make sure that the bowl fits tightly.
Thread the bowl into the cap and place the cap back on the bottle.
Put the bottle in a bucket (tub, trash can, ect.) of water. Hold a lighter to the bowl and pull up on the bottle to draw the smoke in.
Remove your cap and place your lips over the opening. Push the bottle back into the water while inhaling.
Posted in 
Tags: 
Start with the rolling paper “sticky side up.” Keep in mind that loading too little marijuana will result in a “pinner,” while loading too much will prevent the joint from closing properly.
Roll the bottom end of the paper up and tuck it over the top of the weed while pulling end to end (to ensure tightness). Continue to roll the paper from the bottom up until only the sticky strip is showing.
Lick the sticky strip of the paper and seal the joint. Lightly twist both ends of the joint so that weed isn’t sucked into your mouth as you inhale.
